User manual

1-4 HS-51/HS-51X Wireless Handheld Reader User Manual

Charge the Reader

• Plug the USB charge cable into the Charging Station’s USB connector.

• Plug the other end of the USB cable into a USB port on your PC.

• Place the reader into the Charging Station. Be sure that the battery has already been

installed in the reader.

Note: Batteries ship with approximately 50% battery life and must be charged to

100% before first use. Approximate time required to charge a depleted battery is four

hours via USB cable.

Power-on the reader once it is charged to 100% by pulling and holding the trigger for

approximately one second. The reader will beep and vibrate and the LEDs will flash to

indicate that it has been powered on.

Note: Pressing and holding the buttons on the top of the reader will also power it on.

Charging Station with

Embedded Modem

Charging Station without Embedded

Modem (Accessory Only)