User manual

HS-51/HS-51X Wireless Handheld Reader User Manual 4-7
Communications
Configuring and Using Batch Mode
Follow the procedure below to set up and use Batch Mode.
• Plug in the Charging Station with Embedded Modem.
• Move the switch on the Charging Station with Embedded Modem to the left (opposite the
direction of the arrow on the switch).
• Decode the Default Reader Settings symbol.
• Decode the Clear All Stored Data, Images, and JavaScripts symbol.
• Decode the Batch Mode Enabled – Log Only symbol.
• Decode the USB Keyboard Mode symbol.
• Use the reader to capture symbol data and log it to the reader as needed. The Storage
Icon on top of the reader will illuminate as symbols are decoded and logged.
• Place the reader in the Charging Station with Embedded Modem’s dock to transfer
logged data to the PC. A Microsoft Keyboard driver will load and data will then be sent to
the PC after approximately 10 seconds.
Default Reader Settings
Clear All Stored Data, Images, and JavaScripts
Batch Mode Enabled – Log Only
USB Keyboard Mode