User guide

Chapter 1: Introduction

Microscan MS-3 Laser Scanner Device Driver User Guide

3. Some software device drivers only. Set the Approach height and

Allowed/prohibited labware. Follow the procedure in “Setting

general properties” on page 16.

4. Set the Barcode Readers location. Follow the procedure in “Setting

barcode location” on page 17.

5. Assign the Lab

ware used by the location by selecting the correct

labware type from the list.

6. In the

Device Properties, select the desired profile if it is not already

selected.

7. Select Fi

le > Device File > Save to save the changes to the device file.

Setting the Use

linked location

Currently, this feature is enabled for the special situations in which there

is a storage device such as a PlateHub Carousel, StoreX, or Cytomat and

a robot, such as the Velocity11 Translator robot that is shuttling plates

between systems.

To use this feature, select yes and then select the device location to

hich you want to link. This tells the software that the current device

location is the same physical location as the device selected from the

Device to use list.

Note: S

electing this option when it is not enabled will have no effect on

the system.