User manual

[ 45 ]
Voicemail
• LISTEN TO YOUR VOICE MESSAGES
Once you have set up voicemail, you can dial the number in one of
four ways:
• Dial the number using the keypad.
• Press and hold the 1 key.
•Select Listen if there is a notification message in the display.
•Select Messages > Voice messages > Listen to voice messages.
After a brief pause, your phone dials the voicemail number.
Once you connect and the prerecorded greeting begins, follow the
automated instructions to listen to your voice messages.
• AUTOMATE VOICEMAIL
You can insert special characters called “dialing codes” into phone numbers
such as voicemail and then save the number to a 1-touch dialing location.
Dialing codes instruct the receiving system to pause, wait, bypass, or accept
the numbers that follow them in the dialing string.
Note: Each voicemail service can vary. The examples and steps
that follow are for clarification. Check with your wireless provider
if you have specific questions about your voicemail service.
Write down some information
You will need this information in “Set up voicemail with dialing codes” on
page 46. Be sure to record all of the information correctly.
1 Write down your voice mailbox number.
2 Call and check your voicemail as you normally would.
3 Write down your interaction with the recorded prompts step-by-step.
Keep in mind that each voicemail service may vary. However, it should
look something like this:
Dial 2145551212, pause 5 seconds, press 1, pause 2 seconds, enter
1234, press pound key.
6340i.ENv1_9310019.book Page 45 Thursday, July 10, 2003 3:21 PM