User manual
Table Of Contents
- Contents
- 1 For your safety
- 2 General information
- 3 Your phone
- 4 Personal information
- 5 Multimedia
- 6 Messaging
- 7 Tools
- 8 Personalization
- 9 Extras
- 10 Services and Applications
- 11 Connectivity
- 12 Troubleshooting
- 13 Reference Information
- 14 Nokia One-year Limited Warranty
- Appendix A Message from the CTIA
- Appendix B Message from the FDA
- Index
Nokia 6600 User Guide 18 Copyright © 2004 Nokia
• To have a private conversation with one of the participants: Select Options→
Conference→ Private. Scroll to the desired participant and press Private. The
conference call is put on hold in your phone, and the other participants can
still continue talking with each other while you have a private discussion with
one participant only. Once you have finished the private conversation, press
Cancel to return to the conference call.
• To drop one participant from the conference call, select Options→ Conference→
Drop participant, then scroll to the participant and press Drop.
5 To end the active conference call, press .
• ANSWERING A CALL
• To answer an incoming call, press .
• To end the call, press .
If you do not want to answer a call, press .
The caller will hear a ’line busy’ tone.
When a call comes in, press Silence to quickly
mute the ringing tone.
Options during a call
Press Options during a call for some of the
following options:
Mute or Unmute, End active call, End all calls, Hold
or Unhold,
Handset, BT handsfree, New call, Conference,
Private, Drop participant, Answer, and Decline.
Swap is used to switch between the active call and the call on hold.
Transfer is used to connect an incoming call or a call on hold with an active call
and to disconnect yourself from both calls.
Send touch tones is used to send touch tone sequences, for example, passwords or
bank account numbers.
All options may not be available on your phone.
• Key in the digits with - . Each keystroke generates a touch tone,
which is transmitted while the call is active. Press repeatedly to produce:
*, p (inserts a pause of approximately two seconds before, or between touch
tone characters.), and w (if you use this character, the remaining sequence is
not sent until you press Send again during the call). Press to produce #.