User manual

Modify advanced GPRS access point settings
Select Options > Advanced settings.
Select from the following:
Network type — Select the internet protocol type to transfer data to and from your
device. The other settings depend on the selected network type.
Phone IP address (for IPv4 only) — Enter the IP address of your device.
DNS addresses — Enter the IP addresses of the primary and secondary DNS servers, if
required by your service provider. To obtain these addresses, contact your internet
service provider.
Proxy server address — Enter the address of the proxy server.
Proxy port number — Enter the port number of the proxy server.
Wi-Fi access point settings
Select Menu > Settings and Connectivity > Destinations > Access point, and follow
the instructions.
Edit a wireless LAN (Wi-Fi) access point
Select an access point group and access point marked with
. Follow the instructions
from your Wi-Fi service provider.
Select from the following:
Wi-Fi network name — Select Enter manually or Search for networks. If you select
an existing network, the Wi-Fi network mode and Wi-Fi security mode are determined
by the settings of its access point device.
Network status — Define whether the network name is displayed.
Wi-Fi network mode — Select Ad-hoc to create an ad hoc network and to allow
devices to send and receive data directly; a Wi-Fi access point device is not needed. In
an ad hoc network, all devices must use the same Wi-Fi network name.
Wi-Fi security mode — Select the encryption used: WEP, 802.1x, or WPA/WPA2
(802.1x and WPA/WPA2 are not available for ad hoc networks). If you select Open
network, no encryption is used. The WEP, 802.1x, and WPA functions can be used only
if the network supports them.
Homepage — Enter the web address of the starting page.
Use access point — Set the device to create a connection using this access point
automatically or after confirmation.
The available options may vary.
88 Connectivity