User manual
Table Of Contents
- Nokia E61 User Guide
- Warranty and Reference Information
- Contents
- For your safety
- Get started
- Your device
- Transfer content between devices
- Messages
- Make calls
- Contacts
- Calendar
- Clock
- Connectivity
- Internet access points
- Set up an Internet access point for data calls
- Advanced Internet access point settings for data calls
- Set up an Internet access point for packet data (GPRS)
- Advanced Internet access point settings for packet data (GPRS)
- Set up an Internet access point for wireless LAN
- Advanced Internet access point settings for wireless LAN
- Wireless LAN
- Cable connection
- IP passthrough
- Bluetooth
- Infrared
- Data connections
- Connection manager
- Modem
- Mobile VPN
- Email data roaming
- Internet access points
- Web
- Office applications
- Organiser
- Data and software management
- Tools
- Media applications
- Personalization
- Settings
- Security
- Shortcuts
- Battery information
- Care and maintenance
- Additional safety information
- Index
5. Insert the locking catches of the back cover into the corresponding slots (1), and slide the cover in the direction of the arrow
(2).
Instead of a SIM card, you may also have a USIM card, which is an enhanced version of the SIM card and is supported by UMTS
(network service) mobile phones. Contact your service provider for more information.
Insert and remove a memory card
If you have a memory card, follow the instructions to insert and remove it.
See "Memory," p. 15.
1. Remove the battery cover.
2. Insert the memory card (1) fully into the memory card slot (2) to lock in place. Ensure that the contact area is facing down.
3. Replace the battery cover.
4. To remove the memory card, remove the battery cover and push the memory card into the device to activate the release
mechanism. Then, gently pull the card out of your device.
Important: Do not remove the memory card in the middle of an operation when the card is being accessed.
Removing the card in the middle of an operation may damage the memory card as well as the device, and data
stored on the card may be corrupted.
Charge the battery
1. Connect the charger to a wall outlet.
2. Connect the charger to the bottom of the device. If you have a battery charger adapter, connect the charger to the adapter,
and the adapter to the bottom of the device.
3. Connect the power cord to the battery charger adapter. The battery indicator bar starts scrolling on the display. If the battery
is completely discharged, it may take a few minutes before the charging indicator is shown. The device can be used while
charging.
4. When the battery is fully charged, the bar stops scrolling. Disconnect the charger from the device, then from the outlet.
When the battery charge level is too low for operation, the device switches itself off.
G e t s t a r t e d
Copyright © 2006 Nokia. All Rights Reserved. 9