HS-79W_BH-304_with_FCC&IC_notice.
HS-79W_BH-304_with_FCC&IC_notice.fm Page 2 Wednesday, August 8, 2007 6:17 PM ENGLISH DECLARATION OF CONFORMITY Hereby, NOKIA CORPORATION declares that this HS-79W product is in compliance with the essential requirements and other relevant provisions of Directive 1999/5/EC. A copy of the Declaration of Conformity can be found at http://www.nokia.com/phones/ declaration_of_conformity/. 0434 © 2007 Nokia. All rights reserved.
HS-79W_BH-304_with_FCC&IC_notice.fm Page 3 Wednesday, August 8, 2007 6:17 PM ENGLISH countries. Diversion contrary to law is prohibited. Introduction The Nokia Bluetooth Headset BH-304 allows you to make and receive calls while on the move. You can use the headset with compatible devices that support Bluetooth wireless technology. Read this user guide carefully before using the headset. Also read the user guide for your mobile device, which provides important safety and maintenance information.
HS-79W_BH-304_with_FCC&IC_notice.fm Page 4 Wednesday, August 8, 2007 6:17 PM ENGLISH Get started The headset contains the following parts shown on the title page: earloop (1), earpiece (2), power key (3), charger connector (4), microphone (5), volume key (6), indicator light (7), and answer/end key (8). Before using the headset, you must charge the battery and pair the headset with a compatible device. Warning: Use only chargers approved by Nokia for use with this particular enhancement.
HS-79W_BH-304_with_FCC&IC_notice.fm Page 5 Wednesday, August 8, 2007 6:17 PM ENGLISH starts. If charging does not start, disconnect the charger, plug it in again, and retry. Charging the battery fully may take up to 1 hour and 30 minutes. 3. When the battery is fully charged, the indicator light turns to green. Disconnect the charger from the headset and the wall outlet. The fully charged battery has power for up to 6 hours and 30 minutes of talk time or up to 150 hours of standby time.
HS-79W_BH-304_with_FCC&IC_notice.fm Page 6 Wednesday, August 8, 2007 6:17 PM ENGLISH 5. Enter the passcode 0000 to pair and connect the headset to your device. In some devices you may need to make the connection separately after pairing. You only need to pair the headset with your device once. If the pairing is successful, the headset beeps and appears in the device menu where you can view the currently paired Bluetooth devices.
HS-79W_BH-304_with_FCC&IC_notice.fm Page 7 Wednesday, August 8, 2007 6:17 PM ENGLISH progress, and proceed as described in the user guide of your device. To answer or end a call, press the answer/end key. To reject an incoming call, press the answer/end key twice. To adjust the headset volume, press the volume key up or down. To mute or unmute the microphone, press the middle of the volume key. To switch the call between the headset and a compatible device, press and hold the answer/end key.
HS-79W_BH-304_with_FCC&IC_notice.fm Page 8 Wednesday, August 8, 2007 6:17 PM ENGLISH winter conditions, will reduce the capacity and lifetime of the battery. Always try to keep the battery between 15°C and 25°C (59°F and 77°F). A device with a hot or cold battery may not work temporarily, even when the battery is fully charged. Battery performance is particularly limited in temperatures well below freezing. Do not dispose of batteries in a fire as they may explode. Batteries may also explode if damaged.
HS-79W_BH-304_with_FCC&IC_notice.fm Page 9 Wednesday, August 8, 2007 6:17 PM ENGLISH • Do not use harsh chemicals, cleaning solvents, or strong detergents to clean the device. • Do not paint the device. Paint can clog the moving parts and prevent proper operation. All of the above suggestions apply equally to your device, battery, charger, or any enhancement. If any device is not working properly, take it to the nearest authorized service facility for service.
HS-79W_BH-304_with_FCC&IC_notice.fm Page 10 Wednesday, August 8, 2007 6:17 PM ENGLISH installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation.