Nokia Bluetooth Headset BH-108 4 2 1 3 5 6 7 8 9
ENGLISH DECLARATION OF CONFORMITY Hereby, NOKIA CORPORATION declares that this BH-108 product is in compliance with the essential requirements and other relevant provisions of Directive 1999/5/EC. A copy of the Declaration of Conformity can be found at http://www.nokia.com/phones/ declaration_of_conformity/. © 2010 Nokia. All rights reserved. Nokia, Nokia Connecting People and the Nokia Original Accessories logo are trademarks or registered trademarks of Nokia Corporation.
ENGLISH the US and other countries. Diversion contrary to law is prohibited. Introduction With the Nokia Bluetooth Headset BH-108, you can make and answer calls hands-free with your compatible mobile device. Read this user guide carefully before using the headset. Also, read the user guide for the device that you connect to the headset. This product may contain small parts. Keep them out of the reach of small children. The surface of this device is nickelfree.
ENGLISH Get started The headset contains the following parts shown on the title page: earpiece (1), indicator light (2), multifunction key (3), earloop (4), charger connector (5), and microphone (6). Before using the headset, you must charge the battery and pair the headset with a compatible device. Parts of the device are magnetic. Metallic materials may be attracted to the device. Do not place credit cards or other magnetic storage media near the device, because information stored on them may be erased.
ENGLISH The fully charged battery has power for up to 4 hours and 30 minutes of talk time or up to 120 hours of standby time. To check the battery charge when the headset is not connected to a charger, press the multifunction key when the headset is connected to a mobile device. If the indicator light is green, the charge level is sufficient. If the light is yellow, you may need to recharge the battery soon. If the light is red, recharge the battery.
ENGLISH 2. If the headset has not been previously paired with a device, switch on the headset. The headset enters pairing mode, and the green indicator light starts to flash quickly. If the headset has been previously paired with a device, ensure that the headset is switched off, and press and hold the multifunction key for about 5 seconds until the green indicator light starts to flash quickly. 3.
ENGLISH Basic use Place the headset on the ear To activate voice dialling (if your mobile device supports this feature with the headset), when no call is in progress, press and hold the multifunction key for about 2 seconds. Proceed as described in the user guide of the mobile device. To answer or end a call, press the multifunction key. To reject a call, press this key twice. To adjust the volume, use the volume controls on the connected device.
ENGLISH Clear settings or reset To clear all the settings from the headset, switch off the headset, and press and hold the multifunction key for about 8 seconds. The headset beeps twice, and the red and green indicator lights alternate. After the settings are cleared, the headset enters pairing mode. To reset the headset if it stops functioning, even though it is charged, connect the headset to a charger while you press and hold the multifunction key.
ENGLISH battery. If the battery is completely discharged, it may take several minutes before the charging indicator light is displayed. Unplug the charger from the electrical plug and the device when not in use. Do not leave a fully charged battery connected to a charger, since overcharging may shorten its lifetime. If left unused, a fully charged battery will lose its charge over time. Always try to keep the battery between 15°C and 25°C (59°F and 77°F).
ENGLISH • Do not use or store the device in dusty, dirty areas. Its moving parts and electronic components can be damaged. • Do not store the device in high or cold temperature. High temperatures can shorten the life of electronic devices, damage batteries, and warp or melt certain plastics. When the device warms to its normal temperature from a cold temperature, moisture can form inside the device and damage electronic circuit boards. • Do not attempt to open the device.
ENGLISH these products as unsorted municipal waste. For more environmental information, see the product Eco- Declarations at www.nokia.com/ environment. FCC/Industry Canada notice This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: 1. This device may not cause harmful interference; and 2. This device must accept any interference received, including interference that may cause undesired operation.
