Nokia Bluetooth Headset BH-110 User Guide Issue 1
Introduction About your headset With the Nokia Bluetooth BH-110 headset, you can handle calls hands-free, even when you are using two phones at the same time. The surface of this product is nickel-free. Warning: This product may contain small parts. Keep them out of the reach of small children. Parts of the product are magnetic. Metallic materials may be attracted to the product. Do not place credit cards or other magnetic storage media near the product, because information stored on them may be erased.
Get started Keys and parts 1 2 3 4 5 6 Charger connector Indicator light Microphone Multifunction key Earpiece Earloop Charge the battery Before using the headset, you must charge the battery. Warning: Use only chargers approved by Nokia for use with this particular model. The use of any other types may invalidate any approval or warranty, and may be dangerous. Use of unapproved chargers may present a risk of fire, explosion, or other hazard. 1 2 3 Connect the charger to a wall outlet.
When the battery charge is low, the headset beeps every 5 minutes, and the red indicator light flashes. When the battery is charging, the red indicator light is on. Check the battery charge Make sure the headset is switched on, and press . A green light indicates a sufficient charge level. If the light is yellow, you may need to recharge the battery soon. If the light is red, recharge the battery. Switch the headset on or off Switch on Press and hold once. for 2 seconds.
Wear the headset If you want to use the headset with the earloop, attach the earloop to the headset. To detach the earloop, gently pull it from the headset. Slide the earloop behind your ear, and gently push the earpiece against your ear. Carefully bend the earloop around your ear for the best fit. Point the headset towards your mouth. Make calls Make and receive calls To make and receive calls using your headset, you need to connect it to your phone. Make a call Make a call in the normal way.
Reject a call twice. Press Switch a call between your headset and phone for 2 seconds. Press and hold You can redial the last called number or use voice dialling, if your phone supports these features with the headset. Redial the last called number When no call is in progress, press twice. Use voice dialling When no call is in progress, press and hold in the user guide of your phone. for 2 seconds, and follow the instructions Change the volume Set the desired volume level on your connected phone.
End an ongoing call, and activate a held call Press . If you redial or use voice dialling, the call is made on the phone you last had an active call on with the headset. Settings Clear device pairings 1 To switch the headset off, press and hold for 5 seconds. 2 Press and hold for 9 seconds. The headset beeps twice, and the red and green indicator lights alternate. After the pairings are cleared, the headset enters pairing mode.
• • • • • • • • • Keep the device dry. Precipitation, humidity, and all types of liquids or moisture can contain minerals that corrode electronic circuits. If your device gets wet, allow the device to dry. Do not use or store the device in dusty or dirty areas. Moving parts and electronic components can be damaged. Do not store the device in high temperatures. High temperatures can shorten the life of the device, damage the battery, and warp or melt plastics.
/Issue 1 EN
