Nokia Bluetooth Headset BH-219 6 1 2 5 7 3 4 8 Issue 1
10 9 11 13 12
14
ENGLISH DECLARATION OF CONFORMITY Hereby, NOKIA CORPORATION declares that this BH-219 product is in compliance with the essential requirements and other relevant provisions of Directive 1999/5/EC. A copy of the Declaration of Conformity can be found at http://www.nokia.com/phones/ declaration_of_conformity/. © 2010 Nokia. All rights reserved. Nokia, Nokia Connecting People and the Nokia Original Accessories logo are trademarks or registered trademarks of Nokia Corporation.
ENGLISH Introduction With the Nokia Bluetooth Headset BH-219, you can make and answer calls hands-free with your compatible mobile device. Read this user guide carefully before using the headset. Also, read the user guide for the device that you connect to the headset. The surface of this device is nickelfree. This product may contain small parts. Keep them out of the reach of small children.
ENGLISH Get started The headset contains the following 1. Connect the charger to a wall parts shown on the title page: outlet. multifunction key (1), Near Field 2. Connect the charger cable to the Communication (NFC) area (2), charger connector (8). The red charger connector (3), microphone (4), indicator light is displayed during earloop (5), earpiece (6), and indicator charging. light (7). Charging the battery fully may take Before using the headset, you must up to 2 hours.
ENGLISH press the multifunction key when the headset is connected to a mobile device. If the indicator light is green, the charge level is sufficient. If the light is yellow, you may need to recharge the battery soon. If the light is red, recharge the battery. When the battery charge is low, the headset beeps every 5 minutes and the red indicator light flashes. Switch the headset on To switch on, press the multifunction key.
ENGLISH to a maximum of two devices at a time. To pair and connect the headset to your device if the device supports NFC, make sure the headset is off and NFC is activated in the device, and touch the NFC area of the device with the NFC area of the headset. To pair and connect the headset to your device if the device does not support NFC: 1. Make sure your mobile device is switched on and the headset is off. 2. If the headset has not been previously paired with a device, switch on the headset.
ENGLISH or make the connection in the Bluetooth menu of the device. To manually connect or disconnect your device if it supports NFC, touch the NFC area of the device with the NFC area of the headset. You may be able to set your device so that the headset connects to it automatically. To activate this feature in a Nokia device, modify the paired device settings in the Bluetooth menu. Basic use Change the earpad The headset may be provided with different sized earpads.
ENGLISH Adjust volume multifunction key for about 2 seconds. The headset automatically adjusts the Proceed as described in the user guide volume according to ambient noise. To of the mobile device. To answer or end a call, press the manually adjust the volume, use the multifunction key (14). To reject a call, volume controls of the connected press the multifunction key twice. device.
ENGLISH To connect the headset to the two devices, switch the headset off and back on. Handle calls If the headset can connect to two devices at the same time and you use redialling or voice dialling, the call is made on the device that you last used to make a call when the headset was connected to it. To answer a call on one connected device and end the active call on the other device, press the multifunction key.
ENGLISH Battery and charger information This device has an internal, nonremovable, rechargeable battery. Do not attempt to remove the battery from the device as you may damage the device. This device is intended for use when supplied with power from the following chargers: AC-3, AC-4, AC-5, AC-8, DC-4 and DC-9. The exact charger model number may vary depending on the type of plug. The plug variant is identified by one of the following: E, X, AR, U, A, C, K, or B.
ENGLISH Use the charger for its intended purpose only. Improper use or use of unapproved chargers may present a risk of fire, explosion, or other hazard, and may invalidate any approval or warranty. If you believe the charger is damaged, take it to a service centre for inspection before continuing to use it. Never use a damaged charger. Only use the charger indoors. Take care of your device Handle your device, charger and accessories with care.
ENGLISH • Do not paint the device. Paint can clog the moving parts and prevent proper operation. Recycle Always return your used electronic products, batteries, and packaging materials to dedicated collection points. This way you help prevent uncontrolled waste disposal and promote the recycling of materials. Check product environmental information and how to recycle your Nokia products at www.nokia.com/werecycle, or with a mobile device, www.nokia.mobi/ werecycle.
ENGLISH interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures: Reorient or relocate the receiving antenna. Increase the separation between the equipment and receiver.
