User`s manual

Hardware Installation

2.6 Jumper Settings for ATX Power On/Off Select

(ATX power supply only)

Jumper JPP

ATX Power On/Off Select

Jumper JPP is applicable only for

computers using an ATX power

supply. It is used to select the

method of powering-on/off the

computer.

Pins 1 and 2 On (ATX Switch)

Uses the power button to

power-on the computer. To

power-off the computer, you can

either press the power button

or execute the Shut Down

command in the Windows



95/98 operating system. If you are using

the Shut Down command, make sure “Software Power-off ” in the

Chipset Features Setup of the Award BIOS is set to Enabled. Refer

to chapter 3 of this manual for more information.

Pins 2 and 3 On (Power Supply Switch)

As long as the power supply switch is On, the computer will always

be in its power-on state. The advantage of this setting is when

power returns after a power failure, the computer will continue to

operate. The computer will power-off only when the power supply

switch is Off or the computer has been disconnected.

Important:

If you wish to use the power supply switch to power on/off the

computer, make sure JP2 pins 1, 2 and 3 is set to Off.

2-3 On:

Power Supply Switch

1-2 On: ATX Switch

(default)