HF-310_UG_en1_with_FCC&IC_notice.
HF-310_UG_en1_with_FCC&IC_notice.fm Page 2 Friday, January 9, 2009 2:42 PM DECLARATION OF CONFORMITY Hereby, NOKIA CORPORATION declares that this HF-310 product is in compliance with the essential requirements and other relevant provisions of Directive 1999/5/EC. The product is in conformity with the limits defined in Directive 2004/104/EC (amending Directive 72/245/ EEC), Annex I, paragraph 6.5, 6.6, 6.8 and 6.9. A copy of the Declaration of Conformity can be found at http://www.nokia.
HF-310_UG_en1_with_FCC&IC_notice.fm Page 3 Friday, January 9, 2009 2:42 PM Contents For your safety......................... 4 Attach to a dashboard ....................... 12 1. Introduction ......................... 5 4. Basic use ............................. 14 Bluetooth wireless technology .......... 5 6 7 7 7 Make or end a call .............................. Answer or reject a call ....................... Adjust volume....................................... Switch a call to the connected device.
HF-310_UG_en1_with_FCC&IC_notice.fm Page 4 Friday, January 9, 2009 2:42 PM For your safety For your safety Read these simple guidelines. Not following them may be dangerous or illegal. Read the complete user guide for further information. ROAD SAFETY COMES FIRST Obey all local laws. Always keep your hands free to operate the vehicle while driving. Your first consideration while driving should be road safety.
HF-310_UG_en1_with_FCC&IC_notice.fm Page 5 Friday, January 9, 2009 2:42 PM Introduction 1. Introduction With the Nokia Speakerphone HF-310, you can make and answer calls hands free. You can connect the speakerphone to a compatible mobile device that supports Bluetooth wireless technology. Read this user guide carefully before using the speakerphone. Also, read the user guide for the device that you connect to the speakerphone.
HF-310_UG_en1_with_FCC&IC_notice.fm Page 6 Friday, January 9, 2009 2:42 PM Get started 2. Get started The speakerphone contains the following parts: 1. Power key 2. Microphone 2 1 4 3 3. Speaker 4. Volume wheel 5. Indicator light 6. Answer/end key 7. Charger connector Before using the speakerphone, you must charge the battery and pair the speakerphone with a compatible device. 5 7 6 Parts of the speakerphone are magnetic. Metallic materials may be attracted to the speakerphone.
HF-310_UG_en1_with_FCC&IC_notice.fm Page 7 Friday, January 9, 2009 2:42 PM Get started displayed. Charging the battery fully may take up to 2 hours and 10 minutes. If you use a charger that is connected to the cigarette lighter socket, power must be supplied by a 12-volt car battery. Ensure that the charger is properly inserted in the cigarette lighter socket and does not interfere with the normal operation of the car.
HF-310_UG_en1_with_FCC&IC_notice.fm Page 8 Friday, January 9, 2009 2:42 PM Get started If the speakerphone is not connected to a device within about 30 minutes, it switches off automatically. ■ Pair and connect with another device 1. Ensure that the speakerphone is switched off and your mobile device is switched on. 2. If you have not previously paired the speakerphone with a device, switch on the speakerphone. The speakerphone enters pairing mode, and the green indicator light flashes quickly.
HF-310_UG_en1_with_FCC&IC_notice.fm Page 9 Friday, January 9, 2009 2:42 PM Get started • Move the speakerphone more than 10 metres (33 feet) away from the device. You do not need to delete a pairing with the speakerphone to disconnect it. Connect the speakerphone manually When you switch on the speakerphone, it tries to connect to the device that was last connected to it.
HF-310_UG_en1_with_FCC&IC_notice.fm Page 10 Friday, January 9, 2009 2:42 PM Mount in a car 3. Mount in a car You can attach the speakerphone to the sunvisor, windscreen, or dashboard in your car. ■ General safety instructions The figure shows possible mounting locations. When you install the speakerphone in a car, ensure that it does not interfere with or hinder the systems used in the operation of the vehicle (for example, airbags) or disturb your field of vision while driving.
HF-310_UG_en1_with_FCC&IC_notice.fm Page 11 Friday, January 9, 2009 2:42 PM Mount in a car 1. To attach the speakerphone to the clip, insert the catch on the clip into the slot at the back of the speakerphone (1). Rotate the speakerphone clockwise until it locks into place (2). (To detach the speakerphone, rotate it anticlockwise.) 2. Slide the clip around the sunvisor from the driver’s or passenger’s side (3), and wrap the strap attached to the clip around the sunvisor from the back. 3.
HF-310_UG_en1_with_FCC&IC_notice.fm Page 12 Friday, January 9, 2009 2:42 PM Mount in a car 1. Insert the catch on the mounting device into the slot at the back of the speakerphone (1). Rotate the speakerphone clockwise until it locks into place (2). 2. Locate a safe mounting surface on the windscreen, and clean the surface thoroughly with a glass cleaner and a clean towel.
HF-310_UG_en1_with_FCC&IC_notice.fm Page 13 Friday, January 9, 2009 2:42 PM Mount in a car 2. Insert the catch on the mounting device into the slot at the back of the speakerphone (1). Rotate the speakerphone clockwise until it locks into place (2). 3. Peel off the protective sheet from the adhesive side of the pad (3), and press the pad against the dashboard (4) so that it stays firmly in place. When you peel off the protective sheet from the pad, do not touch the adhesive side. 4.
HF-310_UG_en1_with_FCC&IC_notice.fm Page 14 Friday, January 9, 2009 2:42 PM Basic use 4. Basic use ■ Make or end a call To make a call from your mobile device that is connected to the speakerphone, use the device in the normal way. Speak towards the speakerphone. For optimal performance, check that there are no objects in front of the microphone and that the microphone is in front of you.
HF-310_UG_en1_with_FCC&IC_notice.fm Page 15 Friday, January 9, 2009 2:42 PM Basic use To switch the call back to the speakerphone, switch on the speakerphone (if it is off), or press and hold the answer/end key for about 2 seconds. ■ Clear settings or reset To clear the pairing settings from the speakerphone, press and hold the power key and the answer/end key (for over 4 seconds) until the red and green indicator lights start to alternate.
HF-310_UG_en1_with_FCC&IC_notice.fm Page 16 Friday, January 9, 2009 2:42 PM Battery and charger information 5. Battery and charger information This device has an internal, nonremovable, rechargeable battery. Do not attempt to remove the battery from the device as you may damage the device. This device is intended for use when supplied with power from the following chargers: AC-3, AC-4, AC-5, and DC-4. The exact charger model number may vary depending on the type of plug.
HF-310_UG_en1_with_FCC&IC_notice.fm Page 17 Friday, January 9, 2009 2:42 PM Care and maintenance Care and maintenance Your device is a product of superior design and craftsmanship and should be treated with care. The following suggestions will help you protect your warranty coverage. • Keep the device dry. Precipitation, humidity, and all types of liquids or moisture can contain minerals that will corrode electronic circuits. If your device does get wet, allow it to dry completely.
HF-310_UG_en1_with_FCC&IC_notice.fm Page 18 Friday, January 9, 2009 2:42 PM Care and maintenance responsibility organisations, or your local Nokia representative. Check how to recycle your Nokia products at www.nokia.com/werecycle, or if browsing on a mobile device, www.nokia.mobi/werecycle.
HF-310_UG_en1_with_FCC&IC_notice.fm Page 19 Friday, January 9, 2009 2:42 PM Additional safety information Additional safety information ■ Vehicles RF signals may affect improperly installed or inadequately shielded electronic systems in motor vehicles such as electronic fuel injection systems, electronic antiskid (antilock) braking systems, electronic speed control systems, and air bag systems.
HF-310_UG_en1_with_FCC&IC_notice.fm Page 20 Friday, January 9, 2009 2:42 PM FCC/Industry Canada notice FCC/Industry Canada notice This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: 1. This device may not cause harmful interference; and 2. This device must accept any interference received, including interference that may cause undesired operation.