Server User Manual

Tip #3. Upgrading Small Business Server 2000 from Uniprocessor HAL to Multiprocessor
HAL
Tip #4. Small Business Server 2000 Driver Signatures
Tip #5. Upgrading D5013B NIC Drivers for Small Business Server 2000
Tip #6. Installation Fails to Boot after First Reboot
Tip #7. Small Business Server 2000 Recovery Options
Tip #8. Terminal Server Service is only support the NetServer L Series
Frequently Asked Questions
APPENDIX
On-Line Information and Software Sources
Introduction
This document was created by Hewlett-Packard for the purpose of helping you install Microsoft
Small Business Server 2000 on your HP NetServer based on procedures tested by HP. The
objective of this document is to provide the information needed to achieve the following tasks.
· Install Small Business Server 2000 from Diskette or CD-ROM
· Create boot diskettes from CD-ROM
· Configure system as Domain Controller and DNS Server
· Change IP Address
· Provide installation troubleshooting tips and tricks
Before you start installing or upgrading to Small Business Server 2000 check the following
documents and make sure you develop an action plan to complete the installation. Use the
following informational resources to help you.
· read1st.txt (Small Business Server 2000 CD-ROM)
· readme.doc (Small Business Server 2000 CD-ROM)
· Troubleshooting Tips and Tricks
at the end of this document.
Requirements
· Microsoft Small Business Server 2000 CD-ROM.
· Target system to be tested with minimum of P166 Processor and 64Meg of RAM (128Meg
Recommended).
· One or more Network Interface Cards (NIC).