User Manual
Table Of Contents
- Nokia 9300 User Guide
- Contents
- For your safety
- Getting started
- Installing the SIM card, battery, and memory card
- Charging the battery
- Switching the device on and off
- First start-up
- Keys and connectors
- Communicator interface
- Cover phone
- Volume control
- Instructions in your device
- Using the CD-ROM
- Nokia support on the Web
- Stickers in the sales package
- Transferring data from other devices
- Cover phone
- Desk
- Telephone
- Messaging
- Web
- Contacts
- Documents
- Sheet
- Presentations
- Calendar
- File manager
- Control panel
- Media applications
- Calculator
- Clock
- Data and software management
- Connectivity
- Personalizing your device
- Shortcuts
- Battery information
- CARE AND MAINTENANCE
- Additional safety information
- Index
2. Connect the power cord to the bottom of the device.
See Figure Keys and connectors on page 13. The
battery indicator bar starts scrolling on both
displays. If the battery is totally discharged, it may
take a few minutes before the charging indicator is
shown. The device can be used while charging.
3. When the battery is fully charged, the bar stops
scrolling. Disconnect the charger from the device
and then from the AC outlet.
Switching the device on
and off
To switch the cover phone on, press
and hold the power key. The power
key switches only the cover phone on,
it does not affect the communicator
interface, which switches itself on
when you open the cover. The
communicator interface is switched completely on and
off by inserting and removing the battery. The
communicator interface can be used without the phone
functions when a SIM card is not inserted or when the
Offline profile is selected.
If the device asks for a PIN or security code, enter the
code, and press OK.
To switch the cover phone off, press and hold the
power key. To switch the communicator interface
completely off, remove the battery.
Tip: When you switch the phone on, it may
recognize the SIM card provider and configure
the correct text message, multimedia message,
and GPRS settings automatically. If not, contact
your service provider for the correct settings.
Tip: If you have removed the battery and
inserted it back quickly, you may need to press
the power key once before the communicator
interface starts up.
The communicator interface starts up first after the
battery is inserted. You cannot switch on the cover
phone immediately after the battery has been inserted,
you must wait until the communicator interface has
started.
Antenna
Your device has an internal antenna.
Note: As with any other radio
transmitting device, do not touch the
antenna unnecessarily when the device
is switched on. Contact with the antenna
affects call quality and may cause the
device to operate at a higher power level than
otherwise needed. Avoiding contact with the antenna
area when operating the device optimises the antenna
performance and the battery life.
12
Getting started
file:///C:/USERS/MODEServer/rapi/7167389/rae-6_mini/en/issue_1/rae-6_mini_en_1.xml Page 12 Nov 22, 2004 2:59:20 PMfile:///C:/USERS/MODEServer/rapi/7167389/rae-6_mini/en/issue_1/rae-6_mini_en_1.xml Page 12 Nov 22, 2004 2:59:20 PM