Nokia Japan Ltd. ARCO Tower 6F, 1-8-1, Shimomeguro, Meguro-ku, Tokyo 153-0064, Japan 17th November 2006 Information to users guide for QVVRM-157 Because QVVRM-157 is for sales in China,the users guide is available only in Chinese language. FCC specific parts have been translated to English,see following pages.
R1129_en_2G.book Page 2 Tuesday, November 21, 2006 7:37 AM 0434 DECLARATION OF CONFORMITY Hereby, NOKIA CORPORATION, declares that this RM-157 is in compliance with the essential requirements and other relevant provisions of Directive 1999/5/EC. A copy of the Declaration of Conformity can be found at http://www.nokia.com/phones/ declaration_of_conformity/. The crossed-out wheeled bin means that within the European Union the product must be taken to separate collection at the product end-of-life.
Battery information Charging and discharging Your device is powered by a rechargeable battery. The battery can be charged and discharged hundreds of times, but it will eventually wear out. When the talk and standby times are noticeably shorter than normal, replace the battery. Use only Nokia approved batteries, and recharge your battery only with Nokia approved chargers designated for this device.
Battery information R1129_en_2G.book Page 104 Tuesday, November 21, 2006 7:37 AM from an authorized Nokia dealer, look for the Nokia Original Enhancements logo on the packaging, and inspect the hologram label using the following steps: Successful completion of the four steps is not a total assurance of the authenticity of the battery.
What if your battery is not authentic? If you cannot confirm that your Nokia battery with the hologram on the label is an authentic Nokia battery, please do not use the battery. Take it to the nearest authorized Nokia service point or dealer for assistance. The use of a battery that is not approved by the manufacturer may be dangerous and may result in poor performance and damage to your device and its enhancements. It may also invalidate any approval or warranty applying to the device.
Care and maintenance R1129_en_2G.book Page 106 Tuesday, November 21, 2006 7:37 AM 106 Care and maintenance Your device is a product of superior design and craftsmanship and should be treated with care. The following suggestions will help you protect your warranty coverage. • Keep the device dry. Precipitation, humidity, and all types of liquids or moisture can contain minerals that will corrode electronic circuits.
Additional safety information Your device and its enhancements may contain small parts. Keep them out of the reach of small children. Operating environment Remember to follow any special regulations in force in any area, and always switch off your device when its use is prohibited or when it may cause interference or danger. Use the device only in its normal operating positions.
Additional safety information R1129_en_2G.book Page 108 Tuesday, November 21, 2006 7:37 AM Hearing aids Some digital wireless devices may interfere with some hearing aids. If interference occurs, consult your service provider. Vehicles RF signals may affect improperly installed or inadequately shielded electronic systems in motor vehicles such as electronic fuel injection systems, electronic antiskid (antilock) braking systems, electronic speed control systems, and air bag systems.
To make an emergency call: 1 If the device is not on, switch it on. Check for adequate signal strength. Some networks may require that a valid SIM card is properly inserted in the device. 2 Press the end key as many times as needed to clear the display and ready the device for calls. 3 Enter the official emergency number for your present location. Emergency numbers vary by location. 4 Press the call key.