User Manual

Messaging
47
DRAFT
Messages sent via > Text > Paging, or Fax— to select the format of the
messages to be sent (network service).
Use packet data > Yes — to set GPRS as the preferred SMS bearer
Character support > Full — to select all characters in the messages to be
sent as viewed. If you select Reduced, characters with accents and other
marks may be converted to other characters. When writing a message,
you can check how the message will look to the recipient by previewing
the message. See “Write and send,” p. 30.
Reply via same centre > Yes — to allow the recipient of your message to
send you a reply using your message center (network service)
Multimedia
The multimedia message settings affect the sending, receiving, and
viewing of multimedia messages.
You may receive the configuration settings for multimedia messaging as
a configuration message. See “Configuration settings service,” p. 10.
You can also enter the settings manually. See “Configuration,” p. 67.
Select Menu > Messaging > Message settings > Multimedia msgs. and
one of the following options:
Delivery reports > Yes — to ask the network to send delivery reports
about your messages (network service)
Image size (multimedia) — to define the default image size used in
multimedia messages
Default slide timing — to define the default time between slides in
multimedia messages
Allow multimedia reception > Yes or No — to receive or block the
multimedia message. If you select In home network, you cannot receive
multimedia messages when outside your home network. The default
setting of the multimedia message service is generally In home network.
Incoming multimedia messages — to allow the reception of multimedia
messages automatically, manually after being prompted, or to reject the
reception. This setting is not shown if Allow multimedia reception is set
to No.