User Manual

DRAF
T
8
1. Get started
■ Install the SIM card and battery
Always switch the device off and disconnect the charger before removing the battery.
For availability and information on using SIM card services, contact your SIM card vendor.
This may be the service provider or other vendor.
This phone is intended for use with a BL-4B battery.
Note: Always switch off the power and disconnect the charger and any other device
before removing the cover. Avoid touching electronic components while changing
the cover. Always store and use the device with the cover attached.
To install the SIM card:
• Press and slide the back cover toward the top of the phone to remove it (1).
• To remove the battery, lift it as shown (2).
• Carefully lift the SIM card holder from the finger grip of the phone, and open the flip
cover (3).
• Insert the SIM card, so that the bevelled corner is on the upper left side and the
gold-colored contact area is facing downward (4). Close the SIM card holder, and press it
to lock it into place (5).
• Insert the battery into the battery slot (6).
• Align the back cover with the back of the phone. Slide and push it toward the bottom of
the phone to lock it (7).
■ Charge the battery
Check the model number of any charger before use with this device. This device is intended
for use when supplied with power from an AC-3 charger.
2760_9206392_18Dec2007.fm Page 8 Tuesday, December 18, 2007 10:39 AM