User Manual

Call functions
25
Make a voice dialing call
If an application is sending or receiving data using a packet data
connection, end the application before you use voice dialing.
Voice commands are language-dependent. To set the language, see
Voice playback language in “Phone,” p. 69.
Note: Using voice tags may be difficult in a noisy environment or
during an emergency, so you should not rely solely upon voice dialing in
all circumstances.
1. In the standby mode, press and hold the right selection key. A short
tone is played, and Speak now is displayed.
If you are using a compatible headset with the headset key, press and
hold the headset key to start the voice dialing.
2. Say the voice command clearly. If the voice recognition was
successful, a list with matches is shown. The phone plays the voice
command of the match on the top of the list. After about 1.5
seconds, the phone dials the number; or if the result is not the
correct one, scroll to another entry, and select to dial the entry.
Using voice commands to carry out a selected phone function is
similar to voice dialing. See Voice commands in “My shortcuts,” p. 60.
■ Answer or reject a call
To answer a call, press the call key. To answer the call by opening the
slide, see also Slide call handling in “Call,” p. 68.
To mute the ringing tone before you answer the call, select Silence.
To end the call, or to reject a call, press the end key.
Tip: If the Divert if busy function is activated to divert the calls
(for example, to your voice mailbox), rejecting an incoming call
also diverts the call. See “Call,” p. 68.
If a compatible headset supplied with the headset key is connected to
the phone, to answer and end a call, press the headset key.