User Manual

allow devices to send and receive data
directly; a WLAN access point device is
not needed. In an ad hoc network, all
devices must use the same WLAN
network name.
WLAN security mode — Select the
encryption used: WEP, 802.1x, or WPA/
WPA2. (802.1x and WPA/WPA2 are not
available for ad hoc networks.) If you
select Open network, no encryption is
used. The WEP, 802.1x, and WPA
functions can be used only if the
network supports them.
Use access point — Select After
confirmation to set the device to ask
for confirmation before the connection
using this access point is created or
Automatically to set the device to
connect to the destination using this
access point automatically.
To enter the settings for the selected
security mode, select WLAN security
settings.
Advanced WLAN settings
Select Options > Advanced settings
and from the following:
IPv4 settings — Enter the IP address of
your device, the subnet IP address, the
default gateway, and the IP addresses
of the primary and secondary DNS
servers. Contact your internet service
provider for these addresses.
IPv6 settings — Define the type of DNS
address.
Ad-hoc channel (only for ad hoc
networks) — To enter a channel
number (1-11) manually, select User
defined.
Proxy server address — Enter the
address for the proxy server.
Proxy port number — Enter the proxy
port number.
Active data connections
Select Menu > Ctrl. panel >
Connectivity > Conn. mgr..
Select Active data connections.
In the active data connections view, you
can see the open data connections:
data calls
packet data connections
wireless LAN (WLAN)
connections
Note: The actual invoice for calls and
services from your service provider may
Connectivity 75
© 2010 Nokia. All rights reserved.