User Manual

Call functions
21
Voice commands are language-dependent. To set the language, see
Voice playback language in “Phone,” p. 60.
Note: Using voice tags may be difficult in a noisy environment or
during an emergency, so you should not rely solely upon voice dialing in
all circumstances.
1. In the standby mode, press and hold the right selection key. A short
tone is played, and Speak now is displayed.
If you are using a compatible headset with the headset key, press and
hold the headset key to start the voice dialing.
2. Say the voice command clearly. If the voice recognition was
successful, a list with matches is shown. The phone plays the voice
command of the match on the top of the list. After about
1.5 seconds, the phone dials the number; or if the result is not the
correct one, scroll to another entry, and select to dial the entry.
Using voice commands to carry out a selected phone function is
similar to voice dialing. See Voice commands in “My shortcuts,” p. 53.
■ Answer or reject a call
To answer an incoming call, press the call key, or open the phone. To end
the call, press the end key, or close the phone.
To reject an incoming call if the phone is open, press the end key or close
the phone. To reject an incoming call when the phone is closed, press
the power key.
To mute the ringing tone, press the volume key, or select Silence.
Tip: If the Divert if busy function is activated to divert the calls
(for example, to your voice mailbox), rejecting an incoming call
also diverts the call. See “Call,” p. 59.
If a compatible headset supplied with the headset key is connected to
the phone, to answer and end a call, press the headset key.