User Manual

FCC DRAFT
standards SMTP, IMAP4 (revision 1), and POP3, and with
different push e-mail solutions. Other e-mail providers
may offer services with different settings or features than
those described in this user guide.
Before you can send, receive, retrieve, reply to, and
forward mail on your device, you must also do the
following:
• Configure an Internet access point (IAP). See "Access
points," p. 88.
• Set up an e-mail account, and define the e-mail
settings correctly. See "E-mail account
settings," p. 45.
Follow the instructions from your remote mailbox and
Internet service providers. Contact your network and
Internet service providers or operator for the correct
settings.
Set up your e-mail
Information in this section does not apply, if you are using
a proprietary e-mail client.
If you select Mailbox and have not set up your e-mail
account, you are prompted to do so. To start setting up
the e-mail account with the mailbox guide, select Yes.
1. To start entering the e-mail settings, select Start.
2. Select Mailbox type > IMAP4 > Next or POP3 > Next.
Tip: POP3 is a version of the post office
protocol that is used to store and retrieve e-
mail or Internet mail messages. IMAP4 is a
version of the Internet message access
protocol that lets you access and manage e-
mail messages while the messages are still on
the e-mail server. You can then choose which
messages to download to your device.
3. Select My e-mail address, enter your e-mail address,
and selectNext .
4. Select Incoming mail serv., enter the name of the
remote server that receives your e-mail, and select
Next.
5. Select Outgoing mail serv., enter the name of the
remote server that sends your e-mail, and select
Next. Depending on your e-mail provider, you might
have to use your mobile operator's outgoing mail
server instead of your e-mail provider's.
6. Select Access point, and the Internet access point your
device should use when it retrieves the e-mails. If you
select Always ask, each time the device starts to
retrieve e-mail, it asks which Internet access point it
should use, but if you select an access point, the device
makes the connection automatically. Select Next.
Tip: If you select Select group, the device
makes the connection automatically using
the best available Internet access point from
the access point group. Select the access point
group, and Back to save the selection.
7. Enter a name for your new mailbox, and select Finish.
When you create a new mailbox, the name you give to the
mailbox replaces Mailbox in the Messag. main view. You
can have up to six mailboxes.
Select your default mailbox
If you have defined several mailboxes, you can select one
of them as your default mailbox. To define the default
41
Messages
file:///C:/USERS/MODEServer/mehowell/14385651/rm-88_texas/en/issue_1/rm-88_texas_en_1.xml Page 41 Jan 16, 2006 10:36:24 PMfile:///C:/USERS/MODEServer/mehowell/14385651/rm-88_texas/en/issue_1/rm-88_texas_en_1.xml Page 41 Jan 16, 2006 10:36:24 PM