User Manual

FCC DRAFT
directions. These settings are not available if you select
Active standby > On.
Display settings
Select Display and from the following:
• Light sensor — Adjust the amount of light required to
illuminate the device display.
• Power saver time-out — Select the amount of time
before the screen saver is activated. Activating the
screen saver lengthens the device operating time.
• Light time-out — Set how quickly after last keypress
the display dims.
Call settings
Select Call and from the following:
• Send my caller ID — Select Yes to display your phone
number to the person you are calling or Set by
network to let the network to determine whether your
caller ID is sent.
• Call waiting — Select Activate to be notified of a new
incoming call while you have a call in progress or Check
status to check if the function is active on the network.
• Reject call with SMS — Select Yes to send a text
message automatically to the person who is calling
you informing why you cannot answer their incoming
call.
• Message text — Enter the text that is sent when you
cannot answer an incoming call and want to
automatically send a text message as a reply.
• Automatic redial — Select On to redial a number if it
was busy at the first call attempt. Your device makes a
maximum of 10 attempts to connect the call.
• Summary after call — Select On to briefly display the
approximate duration of the last call.
• 1-touch dialing — Select On to activate speed dialing
on your device. To dial a phone number assigned to
the speed dialing keys (2-9), press and hold the key.
See "1-touch dial," p. 27.
• Anykey answer — Select On to answer an incoming
call by briefly pressing any key, except the end key.
• Line in use — Select Line 1 or Line 2 to change the
phone line for outgoing calls and text messages
(network service). This setting is displayed only if the
SIM card supports the alternate line service and a
subscription to two phone lines.
• Line change — Select Disable to prevent line selection
(network service). To change this setting, you need the
PIN2 code.
Connection settings
Select Menu > Tools > Settings > Connection and from
the following:
• Access points — Set up new or edit existing access
points. Some or all access points may be preset for your
device by your service provider, and you may not be
able to create, edit, or remove them.
• Access point groups — Set up new or edit existing
access point groups that are used in automatic
connection establishment and e-mail roaming.
87
Settings
file:///C:/USERS/MODEServer/mehowell/14385651/rm-88_texas/en/issue_1/rm-88_texas_en_1.xml Page 87 Jan 16, 2006 10:36:24 PMfile:///C:/USERS/MODEServer/mehowell/14385651/rm-88_texas/en/issue_1/rm-88_texas_en_1.xml Page 87 Jan 16, 2006 10:36:24 PM