Owner's manual

 Confirmation – Displays confirmation of success or errors generated while creating the task sequence. Click

Finish to close the New Task Sequence Wizard.

Configuring Driver Selection

To configure the task sequence to use the selection profile, follow these steps:

1. Right-click the production deployment task sequence and select Properties.

2. Select the Task Sequence tab.

3. Expand the Preinstall folder and select the Inject Drivers step as shown in Figure 3.25.

4. Select the selection profile that you created for Surface Pro 3 from the Chose a selection profile: drop down

menu as shown in Figure 3.25.

5. Change the option from Install only matching drivers from the selection profile to Install all drivers from the

selection profile as shown in Figure 3.25.

Note: This will force all drivers selected in the selection profile to be installed, even if the PnP signature is not

available on the system. This is important for Surface devices because some components are not visible until

drivers for other components are installed.

Figure 3.25: Inject Drivers Step with Selection Profile Configuration.