User Guide

Automatic Document Feeder Installation and Operation Manual 3
Installation
Follow these steps to install the Auto-
matic Document Feeder:
1. Pull out the two pins holding the
scanner cover and lift off the cover.
2. Place the Automatic Document
Feeder on top of the scanner. Insert
the guide pins into the holes origi-
nally used by the scanner cover.
Note: The Automatic Document Feeder
for ScanMaker series scanners has
shorter guide pins than other scanner
models.
3. Plug the Automatic Document
Feeder's connector into the Auto-
matic Document Feeder connector
of your scanner. Secure the connec-
tor by tightening its retaining screws.
4. After the Automatic Document
Feeder is securely attached, swing
the paper support up to over 60
degrees. The paper support should
stay in the raised position by itself.
5. Press the Locking Button at the right
side of Automatic Document Feeder.
This will cause the transport module
of Automatic Document Feeder to
pop up a little.
MICROTEK INTERNATIONAL INC.
Pressing the
Locking Button