Manual

MICROTEL D51T
17
Example- Command: **430
Response: Channel four normal state is closed
NOTE: If C=5, the Power Fault channel, the response is:
Example Command: **531
Response: Power fault channel is READY
Command: **530
Response: Power fault channel is OFF
NOTE: When channel 5 is configured OFF it will not call out when a power
failure occurs.
 I/O Return-To-Normal Status Selection of channel c return to normal status
notification. When enabled, the input channel’s return to a normal state after an
alarm will cause a notification callout, using the same list of telephone numbers to
call as an alarm event.
NOTE: Unlike Alarm events, once acknowledged there is NO snooze operation.
*c4 Review I/O channel c return-to-normal configuration
**c41/0 Program I/O channel c return-to-normal configuration
Example- Command: **141
Response: Channel one alarm clear status is enabled.
Example- Command: **440
Response: Channel four alarm clear status is disabled.
 I/O Alarm Setpoint Selection of Low or High Temperature Alarm Setpoints.
Channel 6 is the Low Temperature channel, and Channel 7 is the High Temperature
channel. The following command allows the Low or High temperature alarm
Setpoint to be configured or queried.
NOTE: This command is only valid for c = 6 (Low Temperature) or c = 7 (High
Temperature).
NOTE: The Low and High Temperature Alarms must be ENABLED using the
**c31/0 I/O Alarm Configuration command defined above.
*c5 Review I/O channel c Alarm Setpoint
**c5nn Program I/O channel c Alarm Setpoint
Example- Command: ** 6 5 39
Response: The low temperature alarm point is three nine degrees.
Example- Command: ** 7 5 90