User guide

Chapter Eight – Jukebox Support
125
Pioneer DRM-5004X CD-ROM Changer (Jukebox)
Setting the Physical SCSI IDs
The DRM-5004X has a set of five switches on the rear panel
that are used for setting the SCSI ID (see illustration). The
first four switches set the SCSI ID for each of the internal CD-
ROM drives. Drives 3 and 4 are optional - if not installed, the
switch settings will be ignored. The fifth switch sets the SCSI
ID for the jukebox changer mechanism controller.
Each switch has a tiny “–” (minus) button above and a “+”
(plus) button below it. Pressing these buttons will cycle
through the SCSI IDs from 0 through 7.
Setting the Firmware SCSI IDs
You must also use the Mode Setting buttons on the inside
front right rail to enter the SCSI IDs into the memory of the
Pioneer.
This enables the unit to respond to software that queries it for
the drive IDs.
These settings must match the physical settings of the
switches on the back of the DRM-5004X.
To set the SCSI IDs with the Mode Setting buttons, open the
front door of the jukebox. Hold down the top left button until
the LED display lights. Now press the second button down on
the left to display the SCSI ID of each drive and the changer
mechanism. (See illustration on next page.)
The SCSI ID switches
are located on the
rear panel of the
DRM-5004X.
“+” and “–” buttons
used to select
SCSI ID for each
drive