System Manual

26-0002-0003/5 (en) (2021) 11
2.2 How to Use the Stroke Application & Programming Software (SAPS)
The SAPS has been pre-installed on the commercially available laptop provided.
1. Position the laptop within 1 m of the IPG implanted in the patient’s left chest.
2. Turn the laptop on (Typically the ON button is directly below the laptop screen on the front
left, as shown above in Figure 2.1:, although it may also be on the front right or side of the
computer; press down).
3. The laptop will power up in the “microtransponder” login state. Log into the computer
using the password “mti123”. This password is case-sensitive.
4. The SAPS loaded onto the laptop will then start. A warning will appear that reminds you to
ensure all other applications are closed (see Figure 2.2).
CAUTION: If the laptop does not automatically launch the SAPS and display the
Application Warning Screen (see Figure 2.2), then please reboot your computer and re-
launch SAPS (see Section 13 Troubleshooting ). If this does not correct the issue or
you have additional problems, please contact MicroTransponder per Section 18:
Information and Support.
.
Figure 2.2: Application Warning Screen
5. Select “Close” to dismiss the Application Warning Screen and view the Startup Menu
Screen (Welcome menu) (see Figure 2.3). Before proceeding to the next section, ensure
that you have arrived at this Startup Menu Screen.