Specifications

10 MDS 1710A/C and MDS 2710A/C/D MDS 05-3447A01, Rev. F

NOTE: Use the radio in negative ground systems only.

5. Set the radio conﬁguration. The transceiver is designed for quick

installation with a minimum of software conﬁguration required in

most cases. The selections that must be made or veriﬁed for new

installations are:

• Transmit frequency

• Receive frequency

The operating frequencies are not set at the factory unless they were

speciﬁed at the time of order. Determine the transmit and receive

frequencies to be used, and follow the steps below to program them.

6. Connect a hand-held terminal (HHT) to the

DIAG. connector. When

the HHT beeps, press to receive the ready “>” prompt.

• Set the operating frequencies using the

TX xxx.xxxxx (transmit) and

RX xxx.xxxxx (receive) commands.

• Press after each command. After programming, the HHT

reads PROGRAMMED OK to indicate successful entry.

• Set other transceiver parameters as required. A complete list of

transceiver commands is provided in Section 5.0, TRANSCEIVER

PROGRAMMING.

ENTER