Technical Manual

4 Controlling the HDX-1100 with the Touch Panel

The touch panel screen on the front of the unit lets you perform routine setup and

maintenance functions and control the HDX-1100 directly as described in the following

sections.

4.1 Selecting a Preset or a Channel

The HDX-1100 recalls the most recently saved preset and channel when it is powered up.

You can select from up to nine preset configurations. All presets are set to a customer

supplied plan, or to standard factory defaults, which may changed to suit your needs. Up to

15 RF channels may be configured. To select a preset, do the following:

1. Press the UP or DOWN buttons below the PRESET bar in the display

2. The new PRESET selection will remain so until it is changed.

3. Press the UP or DOWN buttons below the CHANNEL bar in the display

4. The new CHANNEL selection will remain so until it is changed.

4.2 Selecting the RF Output Level

The HDX-1100 recalls the most recently saved RF output power level when it is powered up. To

select between high or low power for the RF output level, do the following:

1. Press PA HIGH/LOW key to toggle between HIGH or LOW RF output level.

2. Press the PA ON/OFF button to toggle between RF on and RF off.

NOTE: When changing channels or presets, the PA will automatically shut off to avoid

interference with other users, as the frequency changes. It must be manually turned on

again once the frequency change is complete (the display will change to new channel

selection).

Please refer to section 8 for complete information on using the local touch screen controller