User's Manual

8
4 Controlling the HDX-1100 with the Touch Panel
The touch panel screen on the front of the unit lets you perform routine setup and
maintenance functions and control the HDX-1100 directly as described in the following
sections.
NOTE: To use the HDX-1100 front panel controls, the RCU panel must be turned off or
disconnected prior to turning the HDX-1100 on.
4.1 Selecting a Preset or a Channel
The HDX-1100 recalls the most recently saved preset and channel when it is powered up.
You can select from up to nine preset configurations. The last four are configured as factory
defaults, but may be changed to suit your needs. Up to 15 RF channels may be configured
To select a preset, do the following:
1. Press the UP or DOWN buttons below the PRESET bar in the display
2. The new PRESET selection will remain so until it is changed.
3. Press the UP or DOWN buttons below the CHANNEL bar in the display
4. The new CHANNEL selection will remain so until it is changed.
4.2 Selecting the RF Output Level
The HDX-1100 recalls the most recently saved RF output power level when it is powered up. To
select between high or low power for the RF output level, do the following:
1. Press PA HIGH/LOW key to toggle between HIGH or LOW RF output level.
2. Press the PA ON/OFF button to toggle between RF on and RF off.
NOTE: When changing channels, the PA will automatically shut off to avoid interference
with other users, as the frequency changes. It must be manually turned on again once
the frequency change is complete (the display will change to new channel selection).
Please refer to section 8 for complete information on using the local touch screen controller