User's Manual

11
6 Configuring the internal HDX-1100 with a PC
The HDX-1100 is based on the ultra-portable Vislink HDT-1000 transmitter that has been
integrated with additional components and subsystems needed to provide a high performance
airborne or mobile transmission system. Presets numbers 6 through 9 of HDT-1000 module are
programmed with factory defaults representing typical video settings that may be used as they
are, or modified to suit your specific operating requirements. A list of factory default presets is
included in Appendix 1 at the end of the manual.
WARNING: Do not attempt to modify, delete, or create new pre-sets until you have a complete
understanding of the video set-up menus described below. If you have any questions in this
regard, please contact Vislink customer service.
To set up the HDX-1100 transmitter with a PC, do the following:
1. Connect a LAN cable to the network connection of a router or switch and the ethernet
port on the HDX-1100.
2. Open a web browser on your PC and type 192.168.1.200 into the URL address field
and press Enter. The screen will change to the HDX-1100 log-in page, as shown
below.
The factory defaults are: User Name = root
Password = root
NOTE: The factory default user name and password should be changed immediately to