User's Manual

Page 45
NewStream User Guide and Technical Manual
Steps to Stream Video in SNG Mode
After confi guring SNG Presets, you can continue in Remote mode to create Channel
Plans to allow quick selection of frequencies used to begin transmitting video and audio
signals. Refer to the Web interface Frequency Plans Page [SNG] section below for
more information. The following steps must be followed to begin Satellite transmission
while in Remote Mode. Each of the steps can also be done using the front panel in
Local mode, the buttons and switches used are noted.
1. Confi gure SNG Presets and then select the preset you will use for broadcast.
In Local mode, you would select using the rocker switch [Figure 5 item H] and then
pressing the Enter button [Figure 5 item J].
2. Set frequency tuning mode method:
a. Frequency Tune BUC disabled [L-Band] - refer to Figure 25.
b. Frequency Tune BUC enabled [Ka or Ku-bands] - refer to Figure 27.
c. Channel Plans setup to quickly tune to pre-confi gured and stored frequency
choices - refer to Figure 26.
3. Set the Power level using the RF Level rocker switch to the desired level [Figure 5
item B].
4. Press CW ON to enable the carrier and readjust the power level as needed. It is
recommended that you start on a lower power level. This action starts unmodulated
satellite transmission.
5. Press MOD ON to begin modulated satellite transmission.
6. Either MOD OFF or CW OFF can be pressed to stop transmission.