User Manual Part 1

Routine Operation 3-69MTX5000 User and Technical Manual
and RFU2 to the respective RF heads on the RF Band drop-
down menu, as required.
If your MTX5000 system is a single band configuration, the RF
head may be connected to either the IDU RFU 1 or RFU 2 rear
panel connector. The MTX5000 software automatically detects
the RF head configuration and connection and assigns RFU 1 or
RFU 2 to the RF head, as applicable.
When the required RF head is selected, the RF Band pull-down
menu will display the selected RF head.
After selecting the RF head, the Channel Plan pull-down menu
option must be selected. When the Channel Plan pull-down
menu option required is selected, the Channel Plan pull-down
menu will display the selected RF band.
1. Verify the MTX5000 system is powered up and the
system is in the remote operating mode.
2. Observe the remote screen is displayed on the remote
PC display. See Figure 3-142.
Figure 3-142: Remote Screen Display - Typical
3. Select the Main tab RF Band pull-down menu and
select the RFU1 or RFU2 option required.
4. Select the Channel Plan pull-down menu and select
the Channel Plan option required.
3.8.3 Select Operating Channel
The procedure required to select an operating channel is
contained in the following steps. When the Channel pull-down
menu option required is selected, the Channel pull-down menu
will display the selected channel.
1. Verify the MTX5000 system is powered up and the
system is in the remote operating mode.
2. Observe the Remote screen is displayed on the
remote PC display. See Figure 3-143.
Figure 3-143: Remote Screen Display - Typical