User Manual Part 1

Routine Operation 3-71MTX5000 User and Technical Manual
2. Observe the Remote screen is displayed on the
remote PC display. See Figure 3-146.
Figure 3-146: Remote Screen Display - Typical
3. Select the Main tab Antenna Polarity pull-down
menu and select the Antenna Polarity pull-down
menu option required.
3.8.7 Enable/Disable Transmitter
The procedure required to enable or disable the Power Amplifier
(PA) (transmitter) is contained in the following steps. When the
new power amplifier operating mode is selected, the PA Control
pull-down menu will display the new operating mode.
1. Verify the MTX5000 system is powered up and the
system is in the remote operating mode.
2. Observe the Remote screen is displayed on the
remote PC display. See Figure 3-147.
Figure 3-147: Remote Screen Display - Typical
3. Select the Main tab PA Control pull-down menu and
select the PA Control pull-down menu option
required.
3.8.8 Select High/Low RF Power Mode
The procedure required to select the power amplifier
(transmitter) high or low RF power output is contained in the
following steps. When the power amplifier output power mode is
selected, the RF Power pull-down menu will display the new
operating mode.
1. Verify the MTX5000 system is powered up and the
system is in the remote operating mode.
2. Observe the Remote screen is displayed on the
remote PC display. See Figure 3-148 on page 3-72.