User Manual Part 1

5
Advanced Operations 5-1MTX5000 User and Technical Manual
Advanced Operations
5.1 Chapter Overview
This chapter describes how to use the software contained in the
MTX5000 to provide password control of advanced operations,
to create or update Preset settings in the Local or Remote mode,
to set an Internet Protocol (IP) address for remote operations,
and to update the MTX5000 software. This information is
provided and intended for use by the technical staff.
Here are the topics covered:
Topic Page
Before You Begin 5-1
MTX5000 5-2
Software 5-2
Settings 5-2
System Rules 5-2
Configuration Settings 5-3
Local Mode Password Control 5-3
Create or Update Preset Configuration Settings in
Local Mode
5-6
Create or Update Custom Analog Preset
Configuration In Local Mode
5-7
Create or Update Digital COFDM Preset
Configuration Settings in Local Mode
5-17
Create or Update Digital ASI Preset
Configuration Settings in Local Mode
5-30
Create or Update Digital LMS-T Preset
Configuration Settings in Local Mode
5-34
5.2 Before You Begin
Before you begin, you should review the following topics.
Create or Update Digital DVB-S Preset
Configuration Settings in Local Mode
5-47
Create or Update Digital IP Preset
Configuration Settings in Local Mode
5-60
Create or Update Preset Configuration Settings in
Remote Mode
5-73
Create or Update Custom Analog Preset
Configuration in Remote Mode
5-73
Create or Update Custom Digital COFDM
Preset Configuration in Remote Mode
5-77
Create or Update Custom Digital ASI Preset
Configuration in Remote Mode
5-82
Create or Update Custom Digital LMS-T Preset
Configuration in Remote Mode
5-86
Create or Update Custom Digital DVB-S Preset
Configuration in Remote Mode
5-91
Create or Update Custom Digital IP Preset
Configuration in Remote Mode
5-96
Preset File Management 5-101
Restore Presets to Defaults 5-102
Save Preset Configurations to a File 5-104
Load Preset Configurations from a File 5-106
Set Network Addresses for Remote Operation 5-114
Firmware Update 5-114
License Manager 5-117