User Manual Part 1

Routine Operation 3-32MTX5000 User and Technical Manual
Note
The ++ offset option is not a valid option for 2 GHz
and 7 GHz channel plans.
8. Select the Offset pull-down menu and select -
(minus), 0 (center), or + (plus) offset, as required.
9. Select the Chan. Select option button and observe
the numeric keypad is displayed. See Figure 3-52.
Figure 3-52: Numeric Keypad
Note
In the following step, channels 1 thru 10 may be
selected for the 2 GHz band; channels 1 thru 14
may be selected for the 7 GHz band.
10. Enter the channel number required, select the ENT
option button, and observe the USER CHANNEL
screen is displayed.
11. Select the Save option button and observe the
Channel screen is displayed.
12. Select the Main option button and observe the Main
screen is displayed.
1 2 3
4
7
5 6
8 9
CLR
0
ESC
ENT
3.6.4 Select Channel Offset
The procedure required to select the channel frequency offset is
contained in the following steps.
When performing the following steps, a navigation option button
to return you to the Main screen will be displayed at the bottom
of the Offset screen.
When the new offset is selected, the Main screen will
automatically be displayed and the updated system status
associated with the Offset option button will display the new
offset.
If the Main option button is selected to return to the Main screen
without selecting a new offset, the Main screen will be displayed
and no changes will be made to current MTX5000 settings.
Note
In the following steps, option buttons may be
selected using either the touch screen or the
function keys and the SEL key.
1. Observe the Main screen is displayed. See Figure 3-
53.
Figure 3-53: Main Screen - Typical
Channel 1 0Offset
Antenna Ant. Pol.Antenna1 V
RFU2
7US
RF Band
Preset A
Analog
4.83 & 5.8, 3MHz Vid Dev
RF Output
XX
dBm
<- Status Setup
Status ->
PA On
SUM
ODU
IDU
RF
L/R
H
L
Offset
Option
Button