User Manual Part 1

Routine Operation 3-61MTX5000 User and Technical Manual
Figure 3-129: MTX5000 Color LCD Display Panel - Typical
Selection of the local/remote operating mode may only be
performed at the MTX5000. You cannot change the local/
remote operating mode from the remote PC.
3.7.2 Remote Screen Display
Notes
Preset configuration settings will be displayed in
the local mode when you are connected to the
MTX5000 IDU via your web browser. All
configuration option settings are inactive in the
local mode, however.
When you are connected to the MTX5000 via your web browser
and are logged in as a user, the display shown in Figure 3-130
will appear on your remote PC display.
When the MTX5000 is in the local mode, the Local Mode
indicator on the remote screen Main tab will be displayed after
logging in using the user password. In the local mode, the
current MTX5000 Preset configuration settings may be
monitored from the remote PC, but no settings can be changed
Channel 1 0Offset
Antenna Ant. Pol.Antenna1 V
RFU1
2G17M
RF Band
Preset A
Analog
4.83 & 5.8, 3MHz Vid Dev
RF Output
XX
dBm
<- Status
Setup
Status ->
PA On
SUM
ODU
IDU
RF
L/R
H
L
L/R Option
Button
in the local mode. When the MTX5000 is in the remote mode,
no indicator is displayed on the remote screen.
Figure 3-130: Remote Screen Display - Typical
In the remote mode, the following MTX5000 settings can be
monitored and/or changed using the remote PC. These settings
are controlled using the Main tab.
•Select Preset
•Select RF Band
•Select Channel Plan
• Select frequency Channel
•Select Antenna
• Monitor current RF Output level
• Select channel frequency Offset
Local Mode
Indicator