User Manual Part 2

Installation 6-13MTX5000 User and Technical Manual
Figure 6-7: TNC Connector Option Wiring
A
B
C
D
E
F
G
H
J
K
L
M
N
P
R
S
T
U
V
W
X
Y
Z
a
b
c
P
R
S
T
U
V
W
X
+12V
+12V
GND
GND
ITT CANNON KPT06F16-26S
+12V
+12V
GND
GND
Harness Connections
for ODU 2 (RFU 2)
Harness Connections
for ODU 1 (RFU 1)
ANT
CONTROL
RFU POWER OUT
RFU 1
RFU 2
H
V
LCP
ANT2
BAND2
GND
+
- - + +
- - + +
1
2
Note
All contacts will accommodate 20 AWG single
conductor wiring only.
6.10 Installing the Fabricated Harness
Wiring mounted in a moving vehicle is subject to extremes of
temperature, humidity, and vibration. MRC recommends the
following good general practices:
• Secure the cabling at close intervals along its entire
length.
• Protect the cabling with additional sheathing or padding
anywhere it passes through a hole or lays against an
obstruction.
• Provide flex relief at any location where the cable must
change direction sharply, to maintain a smooth bend and
prevent kinking.
• Provide strain relief at each connector to absorb any
pulling forces on the cable and prevent damage to the
connector.
6.11 Installing the Outdoor Unit
This section provides the steps required to mount the ODU to a
QuikSet QPT-90 Pan & Tilt Assembly, using the Mounting Plate
that was provided with your MRC antenna. The mounting
hardware is provided with the RFU.
The Mounting Plate is designed to fit the following antennas:
• MRC 2A20/7A30
• MRC 2A20SS/7A30SS
• MRC Ellipse 2000
Details on attaching these antennas to the Mounting Plate can
be found in the installation manual that came with your MRC
antenna.