User Manual Part 2

Installation 6-29MTX5000 User and Technical Manual
6.17.3 Power Down
CAUTION
To allow proper shutdown of MTX5000
internal software, the Main screen must
always be displayed when the power switch
is pressed to off.
Failure to properly power down the
MTX5000 with the Main screen displayed
may corrupt the internal software.
1. Verify the Main screen is displayed on the color LCD
display panel. See Figure 6-20.
Figure 6-20: Main Screen - Typical
2. Raise the power switch protective switch cover, press
the power switch, observe the symbol on the switch
goes off, and close the protective switch cover.
3. Set the power source off, as required.
Channel 1 0Offset
Antenna Ant. Pol.Antenna1 V
RFU2
7US
RF Band
Preset A
Analog
4.83 & 5.8, 3MHz Vid Dev
RF Output
XX
dBm
<- Status Setup Status ->
PA On
SUM
ODU
IDU
RF
L/R
H
L
6.18 Product Modifications
The product you purchased has been carefully designed and
tested, and is warranted to meet specifications when connected
and operated as described in this manual.
Note
If you modify a product without authorization from
MRC, you will void the warranty.
For a complete Warranty statement, refer to the “Notices“ section
at the front of this manual.