User Manual Part 2

Analog Color Bar Generator B-9MTX5000 User and Technical Manual
Figure B-11: Color Bar Generator Default Screen
3. Press control switches 2 and 3 simultaneously for
approximately 5 seconds.
- The video display should now look like Figure B-12.
- The cursor will be positioned at the first character field
of Text Line A. The first character field will be
highlighted in inverse video.
- Note that the second line (TEXT LINE B) is for editing
reference only and cannot be changed.
Figure B-12: Text Line A Display
Text Line A
(16 Characters
Maximum)
Text Line B
(16 Characters
Maximum)
MRC - BOSTON
REMOTE 1
TEXT LINE B
Text Line A
(16 Characters
Maximum)
Not Editable
Inverse Video
Highlight
WRC - BOSTON
M
4. The Color Bar Generator will now be in the Subset
Mode. To use the Character Mode, go to step 6.
5. To move up or down in the list of subsets, press
control switches 1 or 3 until the you reach the desired
subset. See Table B-4 on page B-18.
Note
Perform step 6 thru step 8 for each character field
you wish to change.
6. Press control switch 4 to enter the Character Mode.
7. Press control switches 1 or 3 to scroll up or down in
the full character set until you reach the desired
character. See Table B-3 on page B-17.
8. Press control switch 4 to move to the next character
field. The next character field will be highlighted in
inverse video.
9. When all of Text Line A is correct, press any 3 control
switches simultaneously to save Text Line A into
memory.
10. Observe the screen flashes briefly as Text Line A is
stored. This is normal.
B.3.5 Configure Text Line B
The procedure required to configure Text Line B of the color bar
generator display is contained in the following steps.
1. Verify the “Preliminary Setup Procedure” on page B-4
has been performed.
2. Verify the Color Bar Generator default screen is
displayed. See Figure B-13 on page B-10.