User Manual Part 2

Advanced Operations 5-80MTX5000 User and Technical Manual
Note
In the following step, if a factory default digital
COFDM Preset is to be used to prepare a new
Preset configuration, select the Default option.
If a custom user digital COFDM Preset is to be
updated or is to be used to prepare a new Preset,
select the User option.
15. Use the Presets Option pull-down menu and select
Default or User, as required.
16. Use the Color Bars pull-down menu and select Off,
On, Auto Gen, or Auto Standby, as required.
17. Use the PA State Option pull-down menu to select
Off or Last, as required, and select the Submit option
button.
18. Select the Main tab and observe the Main page is
displayed.
19. Use the Preset pull-down menu to select the default or
user custom digital COFDM Preset required.
20. Select the Setup tab and observe the Setup page is
displayed.
21. Select the COFDM tab and observe the COFDM page
is displayed.
22. Use the Constellation pull-down menu to select
QPSK, 16-QAM, or 64-QAM, as required.
23. Use the FEC pull-down menu to select 1/2, 2/3, 3/4,
5/6, or 7/8, as required.
24. Use the Guard Interval pull-down menu to select
1/32, 1/16, 1/8, or 1/4, as required.
25. Use the RF B/W pull-down menu to select 6 MHz, 7
MHz, 8 MHz, 10 MHz, or 20 MHz, as required.
26. Select the Submit option button.
27. Select the MPEG tab and observe the MPEG page is
displayed.
28. Use the General - Spectrum Invert pull-down menu
to select Normal or Inverted, as required.
29. Use the Video In - Input pull-down menu to select the
input required.
30. Use the Video Input - Noise Reduction pull-down
menu to select On or Off, as required.
31. Use the Video Input - SDI Autoline pull-down menu
to select On or Off, as required.
32. Use the Video Input - HD Test Pattern pull-down
menu to select On or Off, as required.
33. Use the Audio 1 - Mode pull-down menu to select
Dual Mono or Stereo, as required.
34. Use the Audio 1 - Input pull-down menu to select
Test Tone, Analog, SDI Emb, AES-EBU or Channel
Ident, as required.
35. Use the Audio 1 - Standard pull-down menu to select
Off, MPEG Layer II, Linear PCM, or MPEG Layer I,
as required.
36. Use the Audio 1 - Bit Rate pull-down menu to select
the bit rate required.
37. Use the Audio 2 - Mode pull-down menu to select
Dual Mono or Stereo, as required.
38. Use the Audio 2 - Input pull-down menu to select
Test Tone, Analog, SDI Emb, AES-EBU or Channel
Ident, as required.
39. Use the Audio 2 - Standard pull-down menu to select
Off, MPEG Layer II, Linear PCM, or MPEG Layer I,
as required.
40. Use the Audio 2 - Bit Rate pull-down menu to select
the bit rate required.