User Manual Part 2

Advanced Operations 5-81MTX5000 User and Technical Manual
41. Use the Audio 2 - Balance pull-down menu to select
Unbalanced or Balanced, as required.
42. Use the Encoder - Mode pull-down menu to select
Standard or Low Delay, as required.
43. Use the Encoder - Bit Rate text box to enter the bit
rate required.
44. Use the Encoder - Bit Rate Auto pull-down menu to
select On or Off, as required.
45. Use the Encoder - PTS per Picture pull-down menu
to select On or Off, as required.
46. Use the Encoder - Horiz Resolution pull-down menu
to select 720, 704, 544, 480 or 352, as required.
47. Use the Encoder - Profile pull-down menu to select
MP@HL or 422P@HL, as required.
Note
In the following step, if the Bit Rate Auto pull-down
menu option selected was On, the ASI Bit Rate
text box is inactive and cannot be changed. Go to
step 49.
If the Bit Rate Auto pull-down menu option
selected was Off, the ASI Bit Rate text box is
active and the bit rate can be changed.
48. Select the Encoder - ASI Bit Rate text box and enter
the bit rate required.
Note
In the following step, if the Remux pull-down menu
On option is selected, the Bit Rate Auto pull-down
menu will become inactive, the ASI Bit Rate text
box becomes active, and the bit rate can be
changed.
49. Use the Encoder - Remux pull-down menu to select
On or Off, as required.
50. Select the Encoder - GOP Length text box and enter
the group of pictures length required.
51. Use the Encoder - Aspect ratio pull-down menu to
select 16:9 or 4:3, as required.
52. Use the Encoder - VBI pull-down menu to select On
or Off, as required.
53. Select the PID - Video text box and enter the program
identifier, as required.
54. Select the PID - PCR text box and enter the program
identifier, as required.
55. Select the PID - PMT text box and enter the program
identifier, as required.
56. Select the PID - Audio 2 text box and enter the
program identifier, as required.
57. Select the PID - Data text box and enter the program
identifier, as required.
58. Select the PID - Audio 1 text box and enter the
program identifier, as required.
59. Select the Encoding - Service Name text box and
enter the service name, as required.
60. Select the Encoding - Network Name text box and
enter the network name, as required.
61. Use the Encoding - Data Enable pull-down menu to
select Off, TTV Format, CJM2 Format, or Low Delay
CJM2, as required.
62. Use the Encoding - Baud Rate pull-down menu to
select 1200, 2400, 4800, 9600, 19200, or 38400, as
required.
63. Select the Submit option button.