User Manual Part 2

Advanced Operations 5-99MTX5000 User and Technical Manual
26. Select the Submit option button.
27. Select the MPEG tab and observe the MPEG page is
displayed.
28. Use the General - Spectrum Invert pull-down menu
to select Normal or Inverted, as required.
29. Use the Video In - Input pull-down menu to select the
input required.
30. Use the Video Input - Noise Reduction pull-down
menu to select On or Off, as required.
31. Use the Video Input - SDI Autoline pull-down menu
to select On or Off, as required.
32. Use the Video Input - HD Test Pattern pull-down
menu to select On or Off, as required.
33. Use the Audio 1 - Mode pull-down menu to select
Dual Mono or Stereo, as required.
34. Use the Audio 1 - Input pull-down menu to select
Test Tone, Analog, SDI Emb, AES-EBU or Channel
Ident, as required.
35. Use the Audio 1 - Standard pull-down menu to select
Off, MPEG Layer II, Linear PCM, or MPEG Layer I,
as required.
36. Use the Audio 1 - Bit Rate pull-down menu to select
the bit rate required.
37. Use the Audio 2 - Mode pull-down menu to select
Dual Mono or Stereo, as required.
38. Use the Audio 2 - Input pull-down menu to select
Test Tone, Analog, SDI Emb, AES-EBU or Channel
Ident, as required.
39. Use the Audio 2 - Standard pull-down menu to select
Off, MPEG Layer II, Linear PCM, or MPEG Layer I,
as required.
40. Use the Audio 2 - Bit Rate pull-down menu to select
the bit rate required.
41. Use the Audio 2 - Balance pull-down menu to select
Unbalanced or Balanced, as required.
42. Use the Encoder - Mode pull-down menu to select
Standard or Low Delay, as required.
43. Use the Encoder - Bit Rate text box to enter the bit
rate required.
44. Use the Encoder - Bit Rate Auto pull-down menu to
select On or Off, as required.
45. Use the Encoder - PTS per Picture pull-down menu
to select On or Off, as required.
46. Use the Encoder - Horiz Resolution pull-down menu
to select 720, 704, 544, 480 or 352, as required.
47. Use the Encoder - Profile pull-down menu to select
MP@HL or 422P@HL, as required.
Note
In the following step, if the Bit Rate Auto pull-down
menu option selected was On, the ASI Bit Rate
text box is inactive and cannot be changed. Go to
step 49.
If the Bit Rate Auto pull-down menu option
selected was Off, the ASI Bit Rate text box is
active and the bit rate can be changed.
48. Select the Encoder - ASI Bit Rate text box and enter
the bit rate required.