User Manual Part 2

Advanced Operations 5-112MTX5000 User and Technical Manual
14. Enter the Gateway address, select the ENT key, and
observe the Radio Network screen is displayed.
15. Select the DNS Server option button and observe the
numeric keypad is displayed.
16. Enter the DNS Server address, select the ENT key,
and observe the Radio Network screen is displayed.
17. Select the Back option button and observe the
Network Config screen is displayed.
Note
If you do not have the IP option installed, the File
Network option button will be inactive (greyed-out)
in the following step.
If the File Network option button is inactive, go to
step 25.
18. Select the File Network option button and observe the
File Network screen is displayed. See Figure 5-232.
Figure 5-232: File Network Screen - Typical
File Network IP Address
Back
Subnet Mask
Gateway
Main
Note
When entering File Network addresses in the
following steps, the addresses cannot be the same
as the Radio Network addresses.
19. Select the IP Address option button and observe the
numeric keypad is displayed. See Figure 5-233.
Figure 5-233: Numeric Keypad
20. Enter the IP address, select the ENT key, and observe
the File Network screen is displayed.
21. Select the Subnet Mask option button and observe
the numeric keypad is displayed.
22. Enter the Subnet Mask address, select the ENT key,
and observe the File Network screen is displayed.
23. Select the Gateway option button and observe the
numeric keypad is displayed.
24. Enter the Gateway address, select the ENT key, and
observe the File Network screen is displayed.
25. Select the Back option button and observe the
Network Config screen is displayed.
26. Select the Trap Config option button and observe the
Trap Config screen is displayed. See Figure 5-234 on
page 5-113.
1 2 3
ESC
0
4
7
5 6
8 9
CLR
0
ESC
ENT