User Manual Part 2

Advanced Operations 5-114MTX5000 User and Technical Manual
Figure 5-235: Remote Screen Display - Typical
36. Perform “Select Local/Remote Operation Mode” on
page 3-20 and set the MTX5000 for remote mode
operation.
37. Verify operations can be performed from a remote PC
by performing any selected procedure contained in
“Remote Location Operations” on page 3-67.
38. When remote operations are verified, select the
MTX5000 IDU Main screen L/R option button to
change it to L (local mode), as required.
5.8 Firmware Update
CAUTION
Avoid damage to the color LCD display
panel when performing the following
procedures!
The color LCD display panel touch screen
may be damaged if a sharp, hard-pointed
object, such as a pencil or a pen, is used to
select the displayed options.
Touch screen options must only be selected
using your fingers, a soft-pointed stylus, or
the front panel function keys.
Damage to the color LCD display panel
caused by using a hard-pointed object or
other misuse may void your warranty on
the MTX5000 IDU.
The procedure required to update firmware in your MTX5000
Indoor Unit (IDU) is contained in the following steps. Firmware
updates must be obtained from the factory. The updates will be
installed in the MTX5000 Indoor Unit (IDU) using a USB flash
drive. The USB flash drive, also referred to as a thumb drive,
memory stick, or memory device is connected to the MTX5000
IDU front panel USB 2.0 connector using a USB-A to USB-B
adapter.
The firmware update procedure can be performed with the
MTX5000 IDU disconnected from the system or can be
performed when the IDU is installed in its normal rack-mounted
position.
It is important that the MTX5000 must not be transmitting
when this procedure is performed.
When updating the firmware in the IDU, you must observe the
following CAUTIONS to avoid corrupting firmware.