User Manual
Table Of Contents
- Notices
- Contents
- Introduction
- Product Description
- Routine Operation
- 3.1 Chapter Overview
- 3.2 Overview of Controls, Indicators and Connectors
- 3.3 Preparing for Operation
- 3.4 Using the Display Screens
- 3.5 PTX-PRO Monitoring Operations
- 3.6 PTX-PRO Control Operations
- 3.7 Front Panel vs. Configurator Settings
- Troubleshooting
- Advanced Operation
- 5.1 Chapter Overview
- 5.2 Before You Begin
- 5.3 Create or Update a Configuration
- 5.3.1 Using the Configurator Software
- 5.3.2 Determine Licensed Options
- 5.3.3 Create New Configuration On-Line
- 5.3.4 Load and Modify Configuration Settings On- Line
- Figure 5-7: Load and Modify Configuration Settings On-Line - Sheet 1 of 5
- Figure 5-8: Load and Modify Configuration Settings On-Line - Sheet 2 of 5
- Figure 5-9: Load and Modify Configuration Settings On-Line - Sheet 3 of 5
- Figure 5-10: Load and Modify Configuration Settings On-Line - Sheet 4 of 5
- Figure 5-11: Load and Modify Configuration Settings On-Line - Sheet 5 of 5
- 5.3.5 Load Configuration File into Radio On-Line
- 5.3.6 Change Preset Names in On-Line Mode
- 5.3.7 Create Channel Plan Offline
- 5.3.8 Modify Channel Plan in Offline Mode
- 5.3.9 Load and Modify a Channel Plan On-Line
- 5.3.10 Load Channel Plan File into Radio On-Line
- 5.3.11 Add Licensed Option
- Installation
- 6.1 Chapter Overview
- 6.2 Unpacking
- 6.3 Initial Inspection
- 6.4 Damage in Shipment
- 6.5 Mounting and Cabling
- 6.6 Power Connections
- 6.7 Grounding
- 6.8 Audio Connections
- 6.9 Signal Connections
- 6.10 Data Connections
- 6.11 Powering Up
- 6.12 Configurator Software Installation
- 6.13 Product Modifications
- Replacement Parts
- Theory of Operation
- Index
Advanced Operation 5-8PTX-PRO User and Technical Manual
Figure 5-5: Create New Configuration On-Line - Sheet 4 of 5
COFDM Tab
Bandwidth
Select 6 MHz, 7
MHz, or 8 MHz,
as required
FEC
Select 1/2, 2/3,
3/4, 5/6, or 7/8,
as required
GuardModulation Type
Select 16 QAM,
64 QAM, or
QPSK, as
required
C
Note
Perform all operations on the COFDM page
for each active Preset, as required.
LMS-T Tab
Bandwidth
Select 10 MHz or
20 MHz, as
required
FEC
2/3 is the only
available option
Guard
Select 1/8 or
1/16, as required
Modulation Type
Select QPSK or
16 QAM, as
required
Note
Perform all operations on the LMS-T page for
each active Preset, as required.
D
Select 1/4, 1/8,
1/16, or 1/32, as
required
From
Figure 5-3
To
Figure
5-6