User Manual

Routine Operation 3-30STRATA TX Operator’s Guide/Tech Ref Manual
Figure 3-27: Main Screen (Typical) - Preset Changed
10. Press the Control Switch for one second to place the
TX System in the transmit mode, as required.
3.6.2 Setting a Channel
The STRATA TX Channel and Offset, other than the Preset
Channel pre-programmed using the STRATA TX Configurator
software, can be selected from the TXU or TCU front panel and
can be configured for operation on any of up to 10 Channels,
with (+) and (-) offsets. For more information, see the “Channels
& Frequencies” Appendix on page A-1.
The frequencies assigned to each Channel must be configured
using the STRATA TX Configurator software. The frequencies
cannot be changed from either the TXU or TCU front panels.
For information on configuring Channels, see the “Configurator
Reference” Appendix on page C-1 (part of the STRATA TX
System Technical Reference Manual only).
Preset
. W
New
Preset
Notes
The Preset will retain the new Channel until the TX
System is powered off. When the TX System is
powered up again, the original Channel setting will
be restored.
When a Preset is changed, the Channel does not
change.
When a Channel is changed, the Preset does not
change.
To select which Channel to modify, perform the following steps:
1. Verify the STRATA TX System is connected and
powered up. See ”Powering the STRATA TX System”
on page 3-12.
2. Observe the Main Screen (Figure 3-28) is displayed.
Figure 3-28: Main Screen
3. Turn the Control Switch ccw until the display reads
Set Channel. See Figure 3-29.
Figure 3-29: Change a Channel (Typical)
Preset 3
. W
Set Channel
Not On Chnl