Operation Manual

9
DL351 Modular I/O
Operator Manual
Chapter 4: Getting Started
This chapter shows you how to connect up, switch on, set up and configure the DL351
Modular I/O unit.
Connecting up
Refer to Figure 2 “Standard system configuration” on page 50 and “Connector panel” on
page 8.
Connect up the following, as appropriate, to the rear panel of your DL351 Modular I/O
unit:
• Inputs/outputs — connect the required input/output cabling to the modules fitted
in slots A to H (see Appendix C “I/O Modules”).
• AES50 — connect the four AES50 audio sockets in the connector panel to the
appropriate AES50 audio sockets (1 to 4) on the DL371 Audio System Engine unit.
• MIDI — connect the three MIDI 5-pin DIN connectors to a MIDI-equipment
instrument, if required.
• GPIO — connect the 25-way D-type connectors to a peripheral device, if required.
• USB — connect a laptop/PC, if required.
• Mains power supply — insert the IEC connectors of the two mains cables into the
rear of the unit and then plug them both into mains power outlets, observing the
precautions detailed in “Power” on page xi.