Manualshelf

Operation Manual

ManualsBrandsMidas ManualsAudioDL371PRO9
49505152535455565758
52 Appendix G: Setting Up A PRO6 System
DL371 Audio System Engine
Operator Manual
Switching the PRO6 Control Centre on/off
Carry out the following to switch the PRO6 Control Centre on or off in a safe manner,
observing all WARNINGS and Cautions.
>> To switch on the PRO6 Control Centre
Caution (1)!
A minimum of two power supply modules must be supplying power
to the PRO6 Control Centre for correct operation.
Caution (2)!
Before switching on, check that all monitor loudspeaker power
amplifiers are turned off or muted.
After connecting up the audio cables, carry out the following:
1 Plug the three mains cables into the mains power outlets.
2 Observing Caution (1)! above, plug the Volex connectors (see “Wiring
instructions” on page 10) of the mains cables into the mains sockets on the rear
of the control centre. (The green LED next to each mains socket will illuminate if
its mains supply is on.)
3 Observing Caution (2)! above, apply power to the PRO6 Control Centre by
switching the D.C. POWER switch on. The PRO6 Control Centre will boot up and,
when the default GUI screens are displayed, it is ready for use.
>> To switch off the PRO6 Control Centre
1 Make sure you have saved any shows, scenes or settings you require.
2 At the GUI, choose homePreferencesShutdown System.
3 At the Shutdown ENTIRE system? prompt, click OK.
4 After the shutdown sequence has finished, switch off the D.C. POWER switch
(rear of control centre).
5 Disconnect the mains cables from the rear of the PRO6.